Miele Appliance Repair in Cheadle West & Gatley

What does error F95 mean on a Miele steam oven?

Error F95 on a Miele steam oven indicates the level switch is blocked by limescale deposits. Descale the oven following the operating instructions using the recommended Miele descaling product. If the fault persists, contact a specialist technician.

What does error F10 mean on a Miele washing machine?

Error F10 on a Miele washing machine indicates the water inlet is blocked or restricted. Check that the water supply tap is fully open, inspect the inlet hose for kinks, and clean the water inlet filter. Miele washing machines require a minimum of 1 bar water pressure.

What does error F16 mean on a Miele washing machine?

Error F16 on a Miele washing machine indicates detergent or rinse aid has been overdosed, causing excessive foam. Reduce the amount of detergent used in future washes. Run a rinse cycle without detergent to clear the excess foam from the system.

What does error F134 mean on a Miele oven?

Error F134 on a Miele oven indicates the internal temperature has exceeded safe limits. Switch off and unplug immediately, leave for 30 minutes to cool. Check the cooling fan and vents are not blocked. If the fault persists, contact a specialist technician.

What does error F mean on a Miele hob?

Error F on a Miele hob indicates one or more sensor controls are covered or soiled. Remove any objects or spillages from the sensor area. Clean the control panel thoroughly. The F indicator will disappear and the hob can be used normally.

Why is my Miele ice maker not producing ice?

Check that the ice maker is switched on and the water supply valve is fully open. Ensure the ice drawer is properly closed, as production will not occur unless it is shut correctly. It can take up to 24 hours for ice production to begin after initial setup. Check that the water filter is not blocked and replace it if the filter indicator light is illuminated. If ice cubes have fused together in the container, discard them and wait for a new batch.

How do I clean the plinth filter on a Miele heat pump dryer?

Place the plinth filter flat in a bowl or bucket, gently press down to loosen residue, and rinse thoroughly until all visible residue is removed. Squeeze out water carefully and place between two towels to dry.

What does fault F66 mean on my Miele tumble dryer?

Fault F66 indicates an airflow blockage. Clean all fluff filters, including the upper filter, lower filter, and perforated laundry deflector. Use a vacuum cleaner with a crevice nozzle to remove fluff from the air flow openings. Check and clean the plinth filter if your model has one. Ensure the exhaust vent is not blocked or kinked. If the problem persists after cleaning, contact a qualified technician.

What should I do if the oven door is dirty after pyrolytic cleaning?

This can occur near the delicate fibreglass seal around the oven compartment. Avoid rubbing or scouring this area. During the pyrolytic cycle, the high temperature removes residues from the inner glass as well as the cavity.

Why are clothes still damp after drying in my Miele washer-dryer?

Check that the moisture sensors inside the drum are clean, as residue or lint build-up can cause premature cycle stops. Clean the fluff filter after every cycle. Ensure the load is not too large for the drying capacity, which is typically smaller than the washing capacity. Select a higher drying level or use the Extra Dry option if available.