Remeha Appliance Repair in Davenport & Cale Green

What does the error E04.13 mean on a Remeha Quinta Ace boiler?

Error E04.13 on a Remeha Quinta Ace boiler indicates the fan speed has exceeded the normal operating range. Contact a commercial heating engineer to verify fan wiring and check for excessive chimney draught affecting the system.

What does the error E5 mean on a Remeha boiler?

Error E5 on a Remeha boiler indicates ionisation failure more than 5 times during one heat demand. The flame is present but not being detected properly. Contact a Gas Safe registered engineer to check CO2 adjustment, ignition probe, and flue connections.

What does the error E04.11 mean on a Remeha Quinta Ace boiler?

Error E04.11 on a Remeha Quinta Ace boiler indicates the VPS gas valve proving has failed. This is a safety-critical gas supply issue. Do not attempt any repairs yourself. Contact a commercial heating engineer immediately to inspect the gas valve connections and replace if defective.

What does the error E11 mean on a Remeha boiler?

Error E11 on a Remeha boiler indicates the air box temperature is too high due to air leaking from the heat exchanger. Contact a Gas Safe registered engineer to check the viewing glass and heat exchanger front plate seals.

What does the error E04.10 mean on a Remeha Quinta Ace boiler?

Error E04.10 on a Remeha Quinta Ace boiler indicates 5 unsuccessful burner start attempts were detected. Check that gas supply is available and the gas meter valve is open. Do not attempt to repair yourself. Contact a commercial heating engineer to check the ignition system, gas supply, electrode condition, and earthing.

Can Remeha Quinta Ace boilers be cascaded?

Yes, the Remeha Quinta Ace is ideally suited for cascade systems. A maximum of four appliances can be cascaded directly from appliance to appliance using quick-connect plug-and-play connectors. The compact boiler dimensions enable rapid installation and flexible siting.

How do I register my Remeha boiler warranty?

To activate your Remeha boiler warranty, registration must be completed within 30 days of commissioning. Your installer should complete the warranty registration form and provide the required documentation. Annual servicing by a Gas Safe registered engineer is required to maintain warranty validity throughout the warranty period.

What is weather compensation on a Remeha boiler?

Weather compensation uses an external temperature sensor to automatically adjust the boiler's flow temperature based on outside weather conditions. When it is warmer outside, the boiler reduces its output; when colder, it increases output. This ensures efficient operation without manual adjustment.

Why is my Remeha boiler not producing hot water?

If your Remeha boiler provides heating but not hot water, check the water pressure first and repressurise if below 1 bar. The diverter valve, which controls flow between heating and hot water, may be faulty. Alternatively, the heat exchanger may be scaled up, particularly in hard water areas.

How do I reset my Remeha boiler?

To reset a Remeha boiler, locate the reset button marked with 'R' on the front panel. Press and hold the reset button for approximately 3 seconds until the boiler restarts. Wait 2 to 3 minutes for the boiler to fire up. If the first attempt fails, you may repeat twice more. If the boiler still fails to fire after the third attempt, check the gas supply.