Zanussi Appliance Repair in Cheadle Hulme South

What does Zanussi dishwasher error code i90 mean?

Error code i90 on a Zanussi dishwasher indicates an electronics failure. Switch off and unplug the dishwasher for at least two hours. Reconnect and run any programme. If the error persists, contact a qualified technician. Have your appliance model number ready when requesting service.

What does Zanussi tumble dryer error code E50 mean?

Error code E50 on a Zanussi tumble dryer indicates a motor or software problem. Switch off and unplug the appliance. Allow the dryer to cool for at least 30 minutes before any inspection. Wait 30 seconds, then reconnect. If the error persists, contact a qualified technician.

What does Zanussi dishwasher error code i80 mean?

Error code i80 on a Zanussi dishwasher indicates an auto door opener malfunction. Switch off and unplug the dishwasher. Check the filter and sump for foam or debris. Clean all filters, reconnect, and run a cycle with AirDry enabled. If the error persists, contact a qualified technician.

What does Zanussi fridge freezer error code E09 mean?

Error code E09 on a Zanussi fridge freezer indicates the freezer temperature is too high, often after a power failure. Set the temperature colder or activate Super Freeze, keep doors closed, and remove any thawed products. If the warning persists after the temperature stabilises, contact a qualified technician.

What does Zanussi dishwasher error code i60 mean?

Error code i60 on a Zanussi dishwasher indicates a heating problem. The water temperature inside the appliance is too high or the temperature sensor has malfunctioned. Switch off and unplug the dishwasher. Ensure the incoming water temperature does not exceed 60°C. Clean the filter and sump, then reconnect and run a test cycle. If the error persists, contact a qualified technician.

Why is my Zanussi tumble dryer not heating up?

If the filters, condenser or heat exchanger are dirty, the machine may not heat up properly. Clean all filters and the condenser. Also check that the room temperature is between 5°C and 35°C - if the ambient temperature is outside this range, the tumble dryer may not operate correctly. Opening the door during a cycle can delay heating by 20 to 30 minutes each time.

How do I clean the moisture sensor on my Zanussi tumble dryer?

The moisture sensor is located on the inner side of the door and detects when your laundry is dry. Clean it using the rough side of a dishwashing sponge with a small amount of vinegar or washing-up liquid. Do not use abrasive materials or steel wool as these can damage the sensor.

How do I clean the condenser on my Zanussi tumble dryer?

Check the condenser once a month and clean it when the condenser indicator flashes on the display. Use a damp cloth or vacuum cleaner with a brush attachment to remove lint. Do not touch the metal surface with bare hands as there is a risk of injury - wear protective gloves. Never operate the dryer when the condenser is blocked with lint as this can damage the machine and increase energy consumption.

Why won't my Zanussi washing machine spin?

Make sure the machine is level by raising or lowering the feet using a spanner and check with a spirit level. Ensure the machine is placed on a stable, hard floor. A very small load can cause balance problems during the spin phase, leading to excessive vibration.

How often should I clean my Zanussi cooker hood metal filters?

Clean the metal filters after approximately 30 hours of use. They can be washed in a dishwasher using an intensive cycle at minimum 65°C, or hand-washed.