Teka Appliance Repair in Edgeley

What does the E2 error mean on a Teka induction hob?

The E2 error on Teka induction hobs indicates that the electronic unit controlling the hob has become too hot. Switch off the hob and allow it to cool down. Check that the hob installation allows for adequate ventilation underneath and ensure the cooling fan vents are not blocked. If the error recurs frequently, contact a specialist technician to review the installation.

What does the C82 error mean on a Teka induction hob?

The C82 error on Teka induction hobs indicates excessive temperature on the glass surface, typically caused by an empty pot or pan being heated. The hob will switch off automatically. Remove the pot or pan from the cooking zone and allow the glass to cool down completely. Never heat empty cookware on an induction hob. If the error persists after cooling, contact a specialist technician.

What does the Err8 error mean on a Teka washing machine?

The Err8 error on Teka washing machines indicates that water has exceeded the protective level, triggering the overflow protection system. Contact a specialist technician as this error indicates a fault with the water level sensing system or inlet valve that requires professional repair.

What does the Err5 error mean on a Teka washing machine?

The Err5 error on Teka washing machines indicates a water level error where the required level has not been reached within 8 minutes. Ensure the water tap is fully open and has adequate pressure. Check that the drain hose is installed at the correct height (80-100 cm) and is not submerged in water. If problems persist, contact a specialist technician.

What does the Err1 error mean on a Teka washing machine?

The Err1 error on Teka washing machines indicates that the door is not properly shut or the door lock is not engaging. Open and firmly close the door until you hear it click. Ensure no clothing is trapped in the door seal. If the error persists, the door lock mechanism may be faulty and require replacement by a technician.

How do I properly load my Teka washing machine?

Never overload the machine as this affects washing results. Load the machine to the maximum capacity shown in the programme table for each programme to save energy and water effectively.

What does SHOW, SHO or DEMO mean on my Teka oven display?

When SHOW, SHO or DEMO appears on your oven display, it means the demonstration mode is activated. In this mode, the oven functions normally but does not heat up. To disable demo mode, disconnect the oven from the power supply for at least 10 seconds, then reconnect it. On some models, you may need to press and hold the + and - buttons for 10 seconds after reconnecting.

What does the filter saturation indicator mean on my Teka cooker hood?

When the saturation indicator illuminates, it means the filters need cleaning. After cleaning, press and hold the designated buttons (typically "+" and "-" or "Timer" and "Light") for at least 3 seconds to reset the indicator.

How do I reset my Teka induction hob after a power cut?

Disconnect the hob from power by switching off at the mains or unplugging it. Wait at least 10 minutes to allow the system to reset, then reconnect and attempt to turn it on again.

Why won't my Teka gas hob burner stay lit?

If the burner ignites but won't stay lit, the thermocouple may be dirty or misaligned. Clean the area around the ignitor and flame failure device with a small brush and ensure they are dry. Check that the burner caps are correctly positioned. If the problem persists after cleaning, the thermocouple may need to be inspected by a specialist technician.