Teka Appliance Repair in Reddish North

What does the ED error mean on a Teka dishwasher?

The ED error on Teka dishwashers indicates a communication failure between the main circuit board and the display panel. Switch off the dishwasher and unplug it from the mains. Wait a few minutes before reconnecting. If the error persists, contact a specialist technician as internal wiring or circuit boards may need inspection or replacement.

What does the E6 error mean on a Teka dishwasher?

The E6 error on Teka dishwashers indicates a water drainage malfunction where the appliance does not pump out the water correctly. Clean the filter at the bottom of the dishwasher. Check that the drain hose is not kinked or blocked. Verify the siphon connection is clear. If the issue persists, the drain pump may need replacing by a technician.

What does the F symbol mean on a Teka induction hob?

The F symbol on Teka induction hobs indicates that a cooking zone is activated but no suitable pot or pan has been detected. Place an induction-compatible pot or pan centrally on the cooking zone. The cookware must have a magnetic base and be the correct size for the zone. If the symbol persists with suitable cookware in place, contact a specialist technician as there may be a fault with the pan detection system.

What does the UNB error mean on a Teka washing machine?

The UNB error on Teka washing machines indicates an unbalanced load where the spin cycle has failed due to uneven distribution of laundry in the drum. Open the door and redistribute the laundry evenly around the drum. Reduce the load size if it is too large and restart the spin cycle. If the problem persists with balanced loads, contact a specialist technician.

What does the Err4 error mean on a Teka washing machine?

The Err4 error on Teka washing machines indicates a heater error where the heating element has failed. This error typically appears at the end of a cycle. Contact a specialist technician as the heating element will likely need testing and replacement.

How do I use combination cooking (microwave and grill) on my Teka microwave?

Press the COMBI button to select the combination mode. C-1 uses 55% microwave and 45% grill power, suitable for fish and similar foods. C-2 uses 36% microwave and 64% grill power. Set the cooking time using the dial and press start.

Why is there water remaining inside my Teka dishwasher at the end of the programme?

If water remains after the wash cycle completes, it usually indicates a drainage issue. Check that the drain pipe is not clogged or kinked, and ensure the dishwasher filters are clean.

Why won't my Teka washing machine door open after the cycle?

The door has a safety lock that remains engaged for approximately 2 minutes after the cycle completes. Wait for the lock to release before attempting to open the door. If the door still won't open, check if there is water remaining in the drum, as the door will not unlock until the water drains. Try running a drain or spin cycle. You can also try unplugging the machine for 20-30 minutes to reset the electronic lock.

Why is my Teka microwave beeping but not starting?

The child lock feature may be activated. To deactivate it, press and hold the corresponding button for 3 seconds until you hear a long beep indicating the lock has been released.

How do I clean the metal filters on my Teka cooker hood?

Release the anchoring points to withdraw the filters. Clean them by soaking in hot water with neutral detergent until the fat dissolves, then rinse under the tap. Alternatively, they can be washed in a dishwasher.