Faber Appliance Repair in Brinnington & Stockport Central

Why is my Faber cooker hood not extracting properly?

Reduced extraction on a Faber cooker hood is usually caused by clogged filters, blocked ducting, or stuck damper flaps. Clean the grease filters thoroughly, replace charcoal filters for recirculation hoods, check the exterior vent for blockages, and ensure ducting is not kinked. If suction remains weak, contact a qualified technician.

Why is my Faber cooker hood motor humming but not spinning?

If your Faber cooker hood motor hums but the fan does not spin, this typically indicates a faulty start capacitor or a seized motor. Switch off the hood at the mains immediately and do not continue using it in this condition. Symptoms may vary by model, so consult your instruction manual for model-specific guidance. Contact a qualified technician for diagnosis and repair.

Why are all LEDs flashing three times on my Faber cooker hood?

When all LEDs flash three times simultaneously on a Faber cooker hood, it confirms that the filter saturation alarm has been successfully reset. This is a confirmation signal, not an error, and no action is required.

Why does my Faber cooker hood turn off automatically after 30 minutes?

If your Faber cooker hood switches off automatically after 30 minutes, the delay function is active. This feature allows the hood to continue extracting residual cooking odours after you finish cooking, then shuts off automatically. To deactivate this function, press and hold the delay button for approximately 3 seconds according to your model's instructions. This is a programmed feature, not a malfunction.

Why are the lights not working on my Faber cooker hood?

If the lights on your Faber cooker hood do not illuminate but the motor works, it may be a bulb, LED strip, or driver failure. Switch off at the mains before any inspection. For halogen models, you may check and replace the bulb with a matching type, avoiding direct skin contact with the new bulb. For LED models, contact a qualified technician as LED components require technical expertise to replace. Consult your instruction manual for model-specific bulb specifications.

How do I clean the metal grease filters on my Faber cooker hood?

Wash the metal grease filters by hand using warm water with neutral or acid-free soap, or place them in the dishwasher. After washing, allow the filters to dry completely before reinstalling.

How do I calculate the extraction rate I need for my Faber cooker hood?

Calculate your required extraction rate by multiplying your kitchen volume (in cubic metres) by 10. For example, a kitchen measuring 5m × 3m × 3m equals 45 cubic metres, requiring a minimum extraction rate of 450 m³/h.

How often should I deep clean the inside of my Faber cooker hood?

Deep clean the interior of your cooker hood and the duct inside the hood once a year. This includes cleaning all accessible internal surfaces where grease may have accumulated beyond the filters.

What cleaning products should I avoid using on my Faber cooker hood?

Avoid using alcohol-based or silicone-based products to clean the inside or outside of your cooker hood, as these can damage the finish. Never use abrasive cleaners, scouring pads, or products containing chlorine. Use only mild soap with a soft cloth or sponge.

Where should the ducting from my Faber cooker hood terminate?

Ducting must terminate outside of your home. A crawl space, attic, basement, or garage does not meet the definition of outside and should not be used as a termination point for the ducting.