Faber Appliance Repair in Davenport & Cale Green

What does a flashing LED light mean on a Faber cooker hood?

A flashing LED light on a Faber cooker hood signals that the activated charcoal filter needs replacing. This alarm appears after approximately 200 hours of operation in recirculation mode. Replace the charcoal filter with a genuine Faber replacement and clean the grease filters, then reset the alarm according to your model's instructions.

Why are the lights not working on my Faber cooker hood?

If the lights on your Faber cooker hood do not illuminate but the motor works, it may be a bulb, LED strip, or driver failure. Switch off at the mains before any inspection. For halogen models, you may check and replace the bulb with a matching type, avoiding direct skin contact with the new bulb. For LED models, contact a qualified technician as LED components require technical expertise to replace. Consult your instruction manual for model-specific bulb specifications.

Why are all LED buttons flashing twice on my Faber cooker hood?

When all LED buttons flash twice simultaneously on a Faber cooker hood, it indicates that the control lock mode has been activated or deactivated. This safety feature prevents accidental changes to hood settings during cleaning. To toggle the lock, press and hold the designated button according to your model's instructions. This is a confirmation signal, not an error.

What does a single LED flash mean on a Faber cooker hood?

A single LED flash on a Faber cooker hood indicates that the remote control receiver has been deactivated. To reactivate the remote control, press the same button for approximately 5 seconds until the LED flashes twice to confirm activation.

Why is my Faber cooker hood not extracting properly?

Reduced extraction on a Faber cooker hood is usually caused by clogged filters, blocked ducting, or stuck damper flaps. Clean the grease filters thoroughly, replace charcoal filters for recirculation hoods, check the exterior vent for blockages, and ensure ducting is not kinked. If suction remains weak, contact a qualified technician.

Is grease on the filters a fire hazard?

Grease deposited on filters is inflammable, which is why regular maintenance is essential. Clean or replace filters according to the recommended schedule based on approximately 3 hours of daily use. Never allow excessive grease to accumulate on the filters.

When should I turn on my Faber cooker hood?

Turn on your cooker hood at least one minute before you start cooking. This allows proper air circulation to be established before cooking vapours and odours are produced.

What duct diameter should I use for my Faber cooker hood?

For cooker hoods with an extraction rate of 300 m³/h or higher, a duct diameter of 150mm is optimal. Alternatively, 120mm ducting may be used. Always use smooth galvanized metal ducting and maintain the same diameter throughout the entire duct run for best performance.

What noise level should I expect from a Faber cooker hood?

A comfortable cooker hood should not exceed 55 dB(A) at maximum speed during normal operation. Faber hoods are designed to minimise noise through optimised internal airflow and components. Models with brushless motors and the Eco function can operate below 40 dB(A) for continuous air circulation.

What is the 24-hour air circulation mode on Faber cooker hoods?

The 24-hour air circulation mode is an eco-friendly feature that runs the hood at very low speed to maintain continuous fresh air exchange in your kitchen. When activated, the hood operates briefly at regular intervals throughout the day, typically below 40 dB(A), with minimal energy consumption.