Faber Appliance Repair in Edgeley

Why does my Faber cooker hood turn on briefly every hour?

If your Faber cooker hood activates for approximately 10 minutes every hour, the 24-hour air circulation mode is enabled. This eco-friendly feature maintains fresh air in your kitchen by periodically ventilating at low speed throughout the day. To deactivate this mode, press and hold the designated button for approximately 2 seconds with the motor and lights off. Consult your instruction manual for model-specific controls.

What does a single LED flash mean on a Faber cooker hood?

A single LED flash on a Faber cooker hood indicates that the remote control receiver has been deactivated. To reactivate the remote control, press the same button for approximately 5 seconds until the LED flashes twice to confirm activation.

Why is my Faber cooker hood making excessive noise or vibrating?

Excessive noise or vibration from a Faber cooker hood is commonly caused by incorrect installation, undersized ducting, or a loose mounting. Verify the hood is securely fixed and that ducting maintains the recommended diameter throughout the entire run without kinks or restrictions. Dirty filters can also increase noise levels. If vibrations persist after checking installation, contact a qualified technician as the motor or impeller may require inspection.

Why is my Faber cooker hood motor humming but not spinning?

If your Faber cooker hood motor hums but the fan does not spin, this typically indicates a faulty start capacitor or a seized motor. Switch off the hood at the mains immediately and do not continue using it in this condition. Symptoms may vary by model, so consult your instruction manual for model-specific guidance. Contact a qualified technician for diagnosis and repair.

Why are the lights not working on my Faber cooker hood?

If the lights on your Faber cooker hood do not illuminate but the motor works, it may be a bulb, LED strip, or driver failure. Switch off at the mains before any inspection. For halogen models, you may check and replace the bulb with a matching type, avoiding direct skin contact with the new bulb. For LED models, contact a qualified technician as LED components require technical expertise to replace. Consult your instruction manual for model-specific bulb specifications.

How often should I replace the charcoal filter on my Faber cooker hood?

Standard charcoal filters should be replaced approximately every 6 months. Faber's Long Lasting charcoal filters can be washed in the dishwasher every 3-4 months and reused for up to 3 years.

What is the Faber Long Lasting charcoal filter and how do I maintain it?

The Long Lasting filter is a reusable active carbon filter with multi-layer technology that can be washed in the dishwasher every 3-4 months and lasts for up to 3 years of normal use. After washing, dry it at room temperature in a vertical position or in an oven at 50°C.

Why is my Faber cooker hood remote control not working?

First check whether the batteries need replacing and install fresh CR2032 batteries if necessary. If this does not solve the problem, the remote control receiver on the hood may be deactivated and needs to be reactivated through the hood's control panel.

What noise level should I expect from a Faber cooker hood?

A comfortable cooker hood should not exceed 55 dB(A) at maximum speed during normal operation. Faber hoods are designed to minimise noise through optimised internal airflow and components. Models with brushless motors and the Eco function can operate below 40 dB(A) for continuous air circulation.

What speed setting should I use on my Faber cooker hood?

Use low speed settings for normal everyday cooking such as boiling pasta or simmering sauces. Reserve high speeds for foods that produce strong odours or smoke, such as frying or grilling.