Faber Appliance Repair in Cheadle Hulme South

What does a steady LED light mean on a Faber cooker hood?

A steady LED light on a Faber cooker hood indicates that the metal grease filters need cleaning. This alarm activates after approximately 100 hours of operation. Remove the filters and wash them by hand or in the dishwasher, then reset the alarm by pressing and holding the reset button for 3-4 seconds until the LEDs flash three times.

Why does my Faber cooker hood turn on by itself?

If your Faber cooker hood turns on automatically without manual activation, it is likely equipped with a heat sensor that detects high temperatures from your hob. This safety feature activates the extraction fan when excess heat builds up, helping to remove smoke and prevent overheating. Some models also feature K-Link technology that synchronises the hood with a compatible Faber induction hob, automatically adjusting extraction based on cooking intensity. This is normal operation for hoods with these features.

What does a single LED flash mean on a Faber cooker hood?

A single LED flash on a Faber cooker hood indicates that the remote control receiver has been deactivated. To reactivate the remote control, press the same button for approximately 5 seconds until the LED flashes twice to confirm activation.

Why is my Faber cooker hood not extracting properly?

Reduced extraction on a Faber cooker hood is usually caused by clogged filters, blocked ducting, or stuck damper flaps. Clean the grease filters thoroughly, replace charcoal filters for recirculation hoods, check the exterior vent for blockages, and ensure ducting is not kinked. If suction remains weak, contact a qualified technician.

Why is my Faber cooker hood motor humming but not spinning?

If your Faber cooker hood motor hums but the fan does not spin, this typically indicates a faulty start capacitor or a seized motor. Switch off the hood at the mains immediately and do not continue using it in this condition. Symptoms may vary by model, so consult your instruction manual for model-specific guidance. Contact a qualified technician for diagnosis and repair.

How do I clean the metal grease filters on my Faber cooker hood?

Wash the metal grease filters by hand using warm water with neutral or acid-free soap, or place them in the dishwasher. After washing, allow the filters to dry completely before reinstalling.

How often should I replace the charcoal filter on my Faber cooker hood?

Standard charcoal filters should be replaced approximately every 6 months. Faber's Long Lasting charcoal filters can be washed in the dishwasher every 3-4 months and reused for up to 3 years.

What is the minimum installation height for a Faber cooker hood above an electric or induction hob?

The minimum distance between the cooker hood and an electric or induction hob is 65cm. If the hob has a larger cooking area, the hood may need to be positioned slightly higher to provide complete coverage.

When should I turn on my Faber cooker hood?

Turn on your cooker hood at least one minute before you start cooking. This allows proper air circulation to be established before cooking vapours and odours are produced.

What is the 24-hour air circulation mode on Faber cooker hoods?

The 24-hour air circulation mode is an eco-friendly feature that runs the hood at very low speed to maintain continuous fresh air exchange in your kitchen. When activated, the hood operates briefly at regular intervals throughout the day, typically below 40 dB(A), with minimal energy consumption.