Faber Appliance Repair in Offerton

What does a steady LED light mean on a Faber cooker hood?

A steady LED light on a Faber cooker hood indicates that the metal grease filters need cleaning. This alarm activates after approximately 100 hours of operation. Remove the filters and wash them by hand or in the dishwasher, then reset the alarm by pressing and holding the reset button for 3-4 seconds until the LEDs flash three times.

What does a flashing LED light mean on a Faber cooker hood?

A flashing LED light on a Faber cooker hood signals that the activated charcoal filter needs replacing. This alarm appears after approximately 200 hours of operation in recirculation mode. Replace the charcoal filter with a genuine Faber replacement and clean the grease filters, then reset the alarm according to your model's instructions.

Why is my Faber cooker hood making excessive noise or vibrating?

Excessive noise or vibration from a Faber cooker hood is commonly caused by incorrect installation, undersized ducting, or a loose mounting. Verify the hood is securely fixed and that ducting maintains the recommended diameter throughout the entire run without kinks or restrictions. Dirty filters can also increase noise levels. If vibrations persist after checking installation, contact a qualified technician as the motor or impeller may require inspection.

Why does my Faber cooker hood run at high speed for only 6 minutes?

When your Faber cooker hood runs at maximum speed and automatically reduces after 6 minutes, this indicates the intensive speed mode is functioning correctly. This timed feature provides maximum extraction power for heavy cooking tasks such as frying or grilling, then automatically returns to a lower speed to conserve energy. This is normal operation, not a fault.

Why does my Faber cooker hood turn off automatically after 30 minutes?

If your Faber cooker hood switches off automatically after 30 minutes, the delay function is active. This feature allows the hood to continue extracting residual cooking odours after you finish cooking, then shuts off automatically. To deactivate this function, press and hold the delay button for approximately 3 seconds according to your model's instructions. This is a programmed feature, not a malfunction.

How often should I replace the charcoal filter on my Faber cooker hood?

Standard charcoal filters should be replaced approximately every 6 months. Faber's Long Lasting charcoal filters can be washed in the dishwasher every 3-4 months and reused for up to 3 years.

Why is my Faber cooker hood noisy?

Noise is generated by the airflow passing through the grease filters during operation. Common causes of increased noise include dirty or clogged filters, undersized ducting, or obstructions in the duct run. Clean or replace filters regularly and ensure ducting is the correct diameter throughout the entire run.

What is the minimum installation height for a Faber cooker hood above an electric or induction hob?

The minimum distance between the cooker hood and an electric or induction hob is 65cm. If the hob has a larger cooking area, the hood may need to be positioned slightly higher to provide complete coverage.

What cleaning products should I avoid using on my Faber cooker hood?

Avoid using alcohol-based or silicone-based products to clean the inside or outside of your cooker hood, as these can damage the finish. Never use abrasive cleaners, scouring pads, or products containing chlorine. Use only mild soap with a soft cloth or sponge.

Why is my Faber cooker hood remote control not working?

First check whether the batteries need replacing and install fresh CR2032 batteries if necessary. If this does not solve the problem, the remote control receiver on the hood may be deactivated and needs to be reactivated through the hood's control panel.