Faber Appliance Repair in Reddish North

Why are all LEDs flashing three times on my Faber cooker hood?

When all LEDs flash three times simultaneously on a Faber cooker hood, it confirms that the filter saturation alarm has been successfully reset. This is a confirmation signal, not an error, and no action is required.

Why does my Faber cooker hood turn on by itself?

If your Faber cooker hood turns on automatically without manual activation, it is likely equipped with a heat sensor that detects high temperatures from your hob. This safety feature activates the extraction fan when excess heat builds up, helping to remove smoke and prevent overheating. Some models also feature K-Link technology that synchronises the hood with a compatible Faber induction hob, automatically adjusting extraction based on cooking intensity. This is normal operation for hoods with these features.

Why does my Faber cooker hood run at high speed for only 6 minutes?

When your Faber cooker hood runs at maximum speed and automatically reduces after 6 minutes, this indicates the intensive speed mode is functioning correctly. This timed feature provides maximum extraction power for heavy cooking tasks such as frying or grilling, then automatically returns to a lower speed to conserve energy. This is normal operation, not a fault.

Why is my Faber cooker hood not extracting properly?

Reduced extraction on a Faber cooker hood is usually caused by clogged filters, blocked ducting, or stuck damper flaps. Clean the grease filters thoroughly, replace charcoal filters for recirculation hoods, check the exterior vent for blockages, and ensure ducting is not kinked. If suction remains weak, contact a qualified technician.

What does a flashing LED light mean on a Faber cooker hood?

A flashing LED light on a Faber cooker hood signals that the activated charcoal filter needs replacing. This alarm appears after approximately 200 hours of operation in recirculation mode. Replace the charcoal filter with a genuine Faber replacement and clean the grease filters, then reset the alarm according to your model's instructions.

What duct diameter should I use for my Faber cooker hood?

For cooker hoods with an extraction rate of 300 m³/h or higher, a duct diameter of 150mm is optimal. Alternatively, 120mm ducting may be used. Always use smooth galvanized metal ducting and maintain the same diameter throughout the entire duct run for best performance.

How do I calculate the extraction rate I need for my Faber cooker hood?

Calculate your required extraction rate by multiplying your kitchen volume (in cubic metres) by 10. For example, a kitchen measuring 5m × 3m × 3m equals 45 cubic metres, requiring a minimum extraction rate of 450 m³/h.

Why is a ducted cooker hood quieter than a recirculating one?

Ducted hoods are quieter because the extracted air passes directly through the ducting without obstruction. In recirculating hoods, the air must pass through charcoal filters in addition to grease filters, creating extra resistance that increases noise levels. This additional filtration step is why recirculating hoods tend to be louder.

What is the minimum installation height for a Faber cooker hood above an electric or induction hob?

The minimum distance between the cooker hood and an electric or induction hob is 65cm. If the hob has a larger cooking area, the hood may need to be positioned slightly higher to provide complete coverage.

What speed setting should I use on my Faber cooker hood?

Use low speed settings for normal everyday cooking such as boiling pasta or simmering sauces. Reserve high speeds for foods that produce strong odours or smoke, such as frying or grilling.