Faber Appliance Repair in Heatons North

What does it mean when the LED flashes twice on a Faber cooker hood?

Two LED flashes on a Faber cooker hood can indicate either that the remote control receiver has been activated, or that the activated charcoal filter alarm has been enabled. This is a confirmation signal showing the hood has registered your command.

What does a steady LED light mean on a Faber cooker hood?

A steady LED light on a Faber cooker hood indicates that the metal grease filters need cleaning. This alarm activates after approximately 100 hours of operation. Remove the filters and wash them by hand or in the dishwasher, then reset the alarm by pressing and holding the reset button for 3-4 seconds until the LEDs flash three times.

Why is my Faber cooker hood not extracting properly?

Reduced extraction on a Faber cooker hood is usually caused by clogged filters, blocked ducting, or stuck damper flaps. Clean the grease filters thoroughly, replace charcoal filters for recirculation hoods, check the exterior vent for blockages, and ensure ducting is not kinked. If suction remains weak, contact a qualified technician.

Why does my Faber cooker hood turn on briefly every hour?

If your Faber cooker hood activates for approximately 10 minutes every hour, the 24-hour air circulation mode is enabled. This eco-friendly feature maintains fresh air in your kitchen by periodically ventilating at low speed throughout the day. To deactivate this mode, press and hold the designated button for approximately 2 seconds with the motor and lights off. Consult your instruction manual for model-specific controls.

Why are the lights not working on my Faber cooker hood?

If the lights on your Faber cooker hood do not illuminate but the motor works, it may be a bulb, LED strip, or driver failure. Switch off at the mains before any inspection. For halogen models, you may check and replace the bulb with a matching type, avoiding direct skin contact with the new bulb. For LED models, contact a qualified technician as LED components require technical expertise to replace. Consult your instruction manual for model-specific bulb specifications.

What is the minimum installation height for a Faber cooker hood above a gas hob?

The minimum distance between the cooker hood and a gas hob must be at least 75cm. This increased distance is required due to the open flames and heat production from gas burners.

Why is a ducted cooker hood quieter than a recirculating one?

Ducted hoods are quieter because the extracted air passes directly through the ducting without obstruction. In recirculating hoods, the air must pass through charcoal filters in addition to grease filters, creating extra resistance that increases noise levels. This additional filtration step is why recirculating hoods tend to be louder.

How do I calculate the extraction rate I need for my Faber cooker hood?

Calculate your required extraction rate by multiplying your kitchen volume (in cubic metres) by 10. For example, a kitchen measuring 5m × 3m × 3m equals 45 cubic metres, requiring a minimum extraction rate of 450 m³/h.

What cleaning products should I avoid using on my Faber cooker hood?

Avoid using alcohol-based or silicone-based products to clean the inside or outside of your cooker hood, as these can damage the finish. Never use abrasive cleaners, scouring pads, or products containing chlorine. Use only mild soap with a soft cloth or sponge.

Are charcoal filters included with Faber cooker hoods?

Charcoal filters are not supplied as standard with most Faber cooker hoods because many models can be either ducted or recirculated. If you plan to use your hood in recirculation mode, you will need to purchase charcoal filters separately.